• To control standard Douglas relays with the Dialog system, use WRD-3408 relay driver.

• Dialog relay drivers are compatible with all models of Douglas relays. 1) Install in relay panels and connect to relays. 2) Connect data signal to driver. 3) Set addresses with DIP switches built into driver.

• WRD-3408 driver has 8 wires, each wire is a unique output for Douglas relays.

• The relay driver can be signaled to switch the connected relay ON or OFF.

• The relay driver continuously senses the state of the connected relays and reports the status to the LCU.

• Relays that switch connected loads in response to a wireless signal
• The WWR-1361 Wireless Relays each have a built-in receiver that responds to ON and OFF signals sent by an associated Douglas WWX-1351 Central Transceiver
• WWR-1361 Wireless Relays can also control 0-10VDC dimming \ballasts
• WWR-1361 Wireless Relays can connect to standard 24VDC occupancy sensors or daylight sensors for daylight harvesting control
• Up to 24 Wireless Relays can be controlled by one Wireless Central Transceiver
• WWR-1361- Wireless Relays can be grouped with other wireless relays and/or with 2-wire relays for control by a master switch
• WWR-1361-Wireless Relays mount to a standard 1/2" knockout

• Enclosed relay circuit which shunts ON emergency lighting circuit during a power outage
• Relay is self-contained within a Plenum, NEMA 1-rated enclosure which is easily mounted through a panel knockout or remotely on a flat surface
• Indicator LED which is ON whenever the relay is activated
• Models available for 120V applications (WR-RIB2401B-EL) and for 277V applications (WR-RIB2402B-EL)

• 1-pole latching relays rated for 16A branch circuits
• Screw terminals on load side and colored pre-stripped leads on control side
• Built-in override lever & ON/OFF indicator
• Fits to standard 1/2" pipe knockout (7/8" hole)
• Designed to easily mount to barriers of WEx Panels for field-assembled systems

• 
  Latching relays rated for 20A branch circuits and 120/277/347V


• 
  Suitable for all types of lighting loads including capacitor-corrected HID ballast


• 
  Built-in override lever & ON/OFF indicator


• 
  2-pole relay available with 480V rating


• 
  Suitable for high inrush duty applications


• 
  Available in the following configurations:
  
  
  
  • 
    WR-6161 (1 pole)
  
  
  • 
    WR-6161-3 (1 pole with auxiliary contact on low-voltage side)
  
  
  • 
    WR-6172 (2 pole with 480V rating)
  
  
  • 
    WR-6172-3 (2 pole with 480V rating and auxiliary contact on low-voltage side)
  
  
  
  


• 
  WR-6161 relays have a UL-certified short circuit current rating (SCCR) of 14,000A.


• 
  Mount to snap rail of Douglas